Portal commands not working

Tried to change portal discharge rate and it said inverter timeout, tried to read the setting to see if it went through only to get inverter timeout again, using the mobile app its still connecting to home and still updating portal info as it should but it seems I cannot make any changes and HA stopped updating about 10 minutes ago.

Anybody else having issues with portal side of things?

Edit
ok, home assistant seems to be updating now, maybe a hiccup? Either that or it WAS updating but the percentage had not changed, I didn't think to check.

If I'm not sure if I'm getting reliable data, I check the givtcp entity for grid frequency, as that is typically always changing.

It usually changes percentage every 5-15 minutes depending on power draw, I caught it at around 10 minutes and forgot due to me trying to figure out what was going on lol

Got discharge going via Home Assistant though now so they are going through its just the remote control page that is chucking up inverter timeouts.

This is what I use and as you can see it can take a bit for it to drop

The reason there are multiple readings is because I still got the default 5m refresh the system gives and I set my old main HA VM to 10 minutes and HA with GivTCP3 to test alongside is set to 60s

Remote control portal just giving this

Edit
Ok, I refreshed the tab and the 6,000 before I change things in home assistant now says this

But when I refresh it I get this

It seems to be working fine for me now, not sure what the issue was and couldn't get anybody else to check if they were experiencing the same.