The inverter is set to Eco mode
The Charging time is set to 1:40 till 6:55 am
Once the set SOC target is reached, the inverter constantly charges and discharges.
![https://ibb.co/h1zYGc2]
Does anyone know what is going on? Is there a way to stop this?
ispookie666 All it is doing is holding it at your set Charge to %, waiting for the timed charge period to end. However, it does seem to be fluctuating quite a bit. Ours is below.
There is a lot of fluctuation! I had not been paying attention to it till I started setting timed charge, but I have not noticed similar behaviour when I have used timed charging.
I wonder if this could be due to the charging being activated by HA and being in the incorrect mode?
ispookie666 These are our charts for last night
The Charge to % was set at 75% and you can see that one entered the period at 75% and bumbled along until the end of the off-peak windows at 5am. The other entered the period at just below 75% and had a short top-up. The house load (including 33kWh of EV charge) was fed from grid and didn't interfere with this at all. The BMS was obviously measuring a relatively stable voltage with only a few short top-ups/discharges to keep the SoC at 75%.
Your chart is from HA? What does your portal chart look like?
Yes it's from HA. I'll check what the portal shows.
I presume the GivTCP data is accurate, as this is reflected in the voltage and current chart from Victron.
Anyone else with HA in similar situation?
Er..... HA?
Just trying to crack the jargon....
S
Spotto home assistant (automation)