Below are the light managing in the document, however I can not get Green Ready, is anyone else having the same issue.
I have set it up on WiFi, and solid blue light.
I have switched to Ethernet as WiFi signal is not good, and now get a flashing Blue Light.
I was expecting it to now go Green Flashing ready to plug in the EV.
Where did you find the table? The EV Charger welcome pack does not show this level of detail. I had a similar problem with my system which was installed to use Ethernet cables rather than WiFi - I could not understand why my EV charger status light was Blue (Flashing) rather than Green (Flashing). All I want to know is whether the charger is online or not. I am not bothered whether the online connection is via WiFi only or cable only if it is connected.
It’s on page 9 of the install manual. I have emailed GE and asked them to look at changing the LED lights to a more understandable sequence.
Green (solid) - Charging
Green (flashing) - car plugged in to cable and ready to charge
Yellow - Comms issue
Blue (Solid) - connection to Internet (WiFi or Ethernet)
Blue (Flashing) - No connection to Internet (WiFi & Ethernet)
Red - Fault
Red (Flashing) - Downloading Firmware