I was under the impression GE had "fixed" the draining battery when charging technical issue.
I have AIO, gateway, GE EV charger.
currently setup to run the house/AIO/EV from the panels not grid (no export mpan yet)
When my EV was super flat, i needed to use octopus intel go to fill the car overnight, but the battery went weird.
As you can see from the first picture which is a normal night my draw is 100-300w with peaks of a few kw when my immersion heater kicks in.
The second picture is when i charged the car, the charger is set to 10a for a slower charge, but it makes no difference if i set it higher, the draw from battery is always the same about 600w
The other oddity is my 3kw peaks from the immersion heater are gone, there are a few bumps.
Either way, my AIO usually drops 20-25% overnight, this time, nearly flat in the morning! sad times.
The third pic is the same night charging, but gateway view.. and on there, the immersion heater peaks are visible, the real house load minus charger is visible, and you can see its pulling from the grid to charge the car etc.
Is this a reality of how things work, setup problem, or install problem?



