Hi there,
Just had the system installed today so just getting to grips with everything.
I got a notification showing the battery had completed calibration; however, when i check the status it shows that it is at 100% but still drawing 1.14kW or so from the grid.
Is this normal and part of the calibration/settling in process; or is something amiss?
i spotted a comment suggesting deactivating the "Eco" mode and reactivating it but no change.
Can anyone advise?
JB1, the reported battery voltage of 53.21 V is not reflective of a fully charged battery, so the calibration is continuing until the upper voltage limit is reached at around 55 to 56 Volts.
Thanks Simon.
Appreciate your help.
Hi again,
I just checked the system status this morning and can see that the battery rapidly discharged at about 1am.
It looks like the battery reached the 55-56 V at around 1am and then discharged in around 1hr. Since the it seems to be idle. (It is set to solar charge only).
A few screenshots below for reference and again appreciate any advice/ knowledge.
JB1 at first sight, that doesn't look good. It was only outputting 500-750W yet dropped to 6% in around an hour.