Remote Control - Delete Setting

Hi all

Using the GivEnergy web site I selected inverter and remote control. It was my intention to set the battery charge setting, just before the peak tariff period, to charge the battery if it was below 30%

Two things, which I would like advice on

1. Even if the battery is well over 30% the battery feed to the house is switched off and power is taken from the grid. Is there a way to set it up so that if the battery is charged it is still used to feed the house?
2. I cannot see any way of deleting the setting, or, disabling it. Can this be done?

Thanks
Terry

TerryWagstaff Even if the battery is well over 30% the battery feed to the house is switched off and power is taken from the grid. Is there a way to set it up so that if the battery is charged it is still used to feed the house?

Interestingly, this is the exact opposite of the behaviour reported in another thread:

CazT I can see that if I set a timed charge to 40% but the battery SoC is >40% at the start of the charging period then it continues to discharge to meet demand until such time at the battery is at 40%. So last night I scheduled 10kWh to go to my car from 00:30 - 2:30 and a timed battery charge to 40% for the whole of the cheap rate period. My starting battery SoC was 58% and I can see it contributed 18% of it's charge to the home demand and then kept state at 40% for the rest of the charging period - perfect!

TerryWagstaff I cannot see any way of deleting the setting, or, disabling it. Can this be done?

Setting both times to 00:00 disables an entry I think.

NorfolkMustard Setting both times to 00:00 disables an entry I think

In practice, setting the start time to the end time has the same effect.
For anyone automating via scripts, it is one less API call to make (unless I'm deluding myself)!